Replacing Your Lash Curler Pads

The silicone pad on your eyelash curler is a consumable component. Over time, the pressure from daily use creates a permanent indentation in the material, which eventually leads to crimping rather than curling.

Neglecting this small piece can lead to uneven tension and, in some cases, the fraying of individual lash hairs. Replacing the pad is a simple maintenance task that requires no specialized knowledge.

Perform this check quarterly or whenever you notice the indentation has become deeper than the silicone surface itself.

1. Extract the existing pad. Open the curler fully to provide maximum clearance. Using your fingernail or the blunt edge of a pair of tweezers, gently pry the edge of the silicone pad upward from the metal channel. Pull the pad out completely, being careful not to bend the metal structure of the curler frame.
2. Clean the metal channel. Inspect the empty metal groove for any accumulation of dried mascara or facial oils. Use a clean cotton swab dipped in a trace amount of rubbing alcohol to remove debris. Ensure the area is completely dry before proceeding, as moisture can prevent the new pad from adhering properly.
3. Insert the new pad. Align the center of the new silicone pad with the center of the metal channel. Push the pad into place starting from one end and working toward the other. Apply firm, even pressure along the entire length of the pad to ensure it sits flush against the metal.
4. Test the tension. Slowly close the curler without lashes inside to ensure the pad sits securely and does not shift. If the pad pops out or feels loose, remove it and re-seat it, ensuring there is no debris trapped underneath. The pad should feel firm and immobile when light pressure is applied.

An indented pad is the primary cause of uneven lash curves.